Nemetschek North America has released its first service pack for the recently introduced Vectorworks 2010. The service pack addresses issues with the wall joining tool and the snap loupe in particular. Additionally, the service pack improves the overall stability and performance of Vectworks 2010.
“Early feedback from our customers indicates that the initial release of Vectorworks 2010 was of very good quality,” says Mark Farnan, Director of Software Development at Nemetschek North America. “We traditionally create a Service Pack for our international localizers about a month after our initial release, and this gives us a great opportunity to fix any problems reported by early adopters.”
Service Pack 1 for Vectorworks 2010 is available for all licenses as a downloadable updater. To install the service pack go the About Vectorworks dialog box in the Vectorworks 2010 application and click Check for Updates.
Vectorworks 2010 line of design software was released on September 15, 2009. To learn more visit: www.vectorworks2010.net